Service Manual

Rev. D
Reelmaster 5500-DSteering and Brakes Page 7 - 4
Specifications
Item Specification
Front wheel lug nut torque 45 to 55 ft-lbs (61 to 75 Nm)
Rear wheel lug nut torque 30 to 35 ft-lbs. (41 to 47 Nm)
Steering cylinder bolt torque 130 to 150 ft-lbs. (176 to 203 Nm)
Rear wheel toe-in 0.000 to 0.125 in. (0.0 to 3.0 mm)
Tire pressure (front and rear) 10 to 15 psi. (0.69 to 1.03 Bar)
Brake pedal free travel 0.5 to 1.0 in. (6.0 to 25.0 mm)
Special Tools
Order these tools from your Toro Distributor.
Hydraulic Tester (Pressure and Flow) - TOR214678
Figure 6
This tester requires O-ring face seal (ORFS) adapter fit-
tings for use on this machine.
1. INLET HOSE: Hose connected from the system cir-
cuit to the inlet side of the hydraulic tester.
2. LOAD VALVE: A simulated working load is created
in the circuit by turning the valve to restrict flow.
3. LOW PRESSURE GAUGE: Low range gauge to pro-
vide accurate reading at low pressure, 0 to 1000 PSI.
A protector valve cuts out when pressure is about to
exceed the normal range for the gauge. The cutout
pressure is adjustable.
4. HIGH PRESSURE GAUGE: High range gauge
which accommodates pressures beyond the capacity of
the low pressure gauge, 0 to 5,000 PSI.
5. FLOW METER: This meter measures actual oil flow
in the operating circuit with a gauge rated at 15 GPM.
6. OUTLET HOSE: A hose from the outlet side of the
hydraulic tester connects to the hydraulic system circuit.