Service Manual

Steering
and Brakes
Reelmaster 5500-D Steering and BrakesPage 7 - 19
Figure 22
3. Slide the spool and sleeve from the housing
(Fig. 22).
4. Remove the thrust bearing and bearing races.
5. Remove the quad seal.
6. Use a small blade screwdriver to carefully pry the
dust seal from the housing. Be careful to not damage the
dust seal seat.
7. Remove the pin that holds the spool and sleeve
together (Fig. 23).
8. Carefully slide the spool out of the sleeve. The
springs and retaining ring will stay with the spool as it is
removed.
9. Remove the retaining ring and springs.
CAUTION
The centering springs are under tension. Re-
move the retaining ring carefully.
Figure 23