Operator's Manual

ManualsBrandsToro ManualsAttachmentsFinishing Kit, DPA Cutting Unit with 5in Reel, Reelmaster 5010-H Series Traction Unit

FormNo.3387-260RevA

FinishingKit

DPACuttingUnitwith5inand7inReels,Reelmaster

5010-H

SeriesTractionUnit

ModelNo.03628

ModelNo.03629

Operator'sManual

Important:Toensurethehoseroutingisappropriate

andthehosesarenottwisted,mountthemotorstothe

cuttingunitsbeforemountingthenishingkits.

1.Onthefrontleftcorneroftheframe(#4cuttingunit

location),removetheextraangeheadnutonthebolt

securingthebulkheadbrackettothemachine(Figure

1).

2.Loosenthenutonthenishingkithosetting,insert

thehoseintotheslotonthebulkheadbracketand

tightenthenut.

Note:Whentighteningthenuts,useabackupwrench

topreventthehosefromtwistingorkinking.

3.Inserttheconnectorplateontothebulkheadmounting

boltswiththeconnectorspositionedasshownin

Figure1.

4.Securetheconnectorplatetooneofthemounting

boltswiththeangenutpreviouslyremoved.

5.Locatethewireharnessonthemachineandplug

thewireconnectorsintothewireconnectorsofthe

nishingkit.

g027210

Figure1

#4cuttingunitlocation,leftfront

1.Extraangeheadnut

3.Bulkheadbracket

2.Connectorplate

6.Repeattheprocedureontheremaining(4)bulkhead

locationsasshowninFigure2thruFigure5.

Important:Theconnectorplatesarepositioned

differentlyattheremaininglocationssothehose

canberoutedthroughthebulkheadbracketandto

thecuttingunitwithoutgettingtwistedorkinked.

g027129

Figure2

#1cuttingunitlocation,centerfront

(Asviewedfromundermachine)

1.Connectorplate

3.Bulkheadbracket

2.Extraangeheadnut

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3387-260*A

Summary of content (2 pages)

PAGE 1
Form No. 3387-260 Rev A Finishing Kit DPA Cutting Unit with 5in and 7in Reels, Reelmaster® 5010-H Series Traction Unit Model No. 03628 Model No. 03629 Operator's Manual Important: To ensure the hose routing is appropriate and the hoses are not twisted, mount the motors to the cutting units before mounting the finishing kits. 6. Repeat the procedure on the remaining (4) bulkhead locations as shown in Figure 2 thru Figure 5.
PAGE 2
1 2 2 3 1 3 g02721 1 Figure 3 #5 cutting unit location, right front 1. Bulkhead bracket g027209 Figure 5 #2 cutting unit location, left rear 3. Extra flange head nut 2. Connector plate 1. Bulkhead bracket 2. Extra flange head nut 2 1 3 g027127 Figure 4 #3 cutting unit location, right rear 1. Extra flange head nut 3. Connector plate 2. Bulkhead bracket 2 3.