Installation Instructions

ManualsBrandsToro ManualsAttachmentsAir Ride Seat Suspension Kit, Reelmaster 5010 Series Traction Unit

FormNo.3385-268RevA

AirRideSeatSuspensionKit

Reelmaster

5010SeriesTractionUnit

ModelNo.03667

InstallationInstructions

Installation

1.Positionthemachineonalevelsurface,lowerthe

cuttingunits,stoptheengine,engagetheparkingbrake

andremovethekeyfromtheignition.

2.Disconnectthenegativebatterycablefromthebattery.

3.Disconnecttheseatswitchwirefromtheharnessat

therearofthecontrolarm.

4.Removethe(2)adjustingboltssecuringthecontrol

armtoseatmount(Figure1).Carefullysetthecontrol

armaside.

Note:Makesurenottodamagethewireharnessor

thethrottlecable.

g026049

Figure1

1.Controlarmadjustingbolts

(2)

2.Controlarmaccesspanel

5.Removethe(4)nutssecuringtheseatadjustersandthe

manualtubeclampstotheseatsuspension(Figure2).

Also,removethe(4)washersbetweentheseatadjusters

andseatsuspension.Carefullysettheseatassembly

aside.

6.Removethe(4)bolts,spacersandnutssecuringthe

lowerseatbracketstotheseatbase(Figure2).Remove

theseatsuspensionandseatbracketsfromtheseat

base.Usecautionnottomisplacethespacersduring

removal.

7.Removethe(4)boltssecuringtheseatsuspensionto

thelowerseatbrackets(Figure2).Retaintheboltsand

bracketsforreuse.

Note:Whenassemblingtheseatcomponents,usethe

frontmountingholesintheseatandtherearmounting

holesinthesuspension.

8.Securetheairrideseatsuspensiontothelowerseat

bracketswiththe(4)boltspreviouslyremoved(Figure

2).

Figure2

1.Seatassembly5.Seatbase

2.Washer(4)6.Spacer

3.Seatsuspension

7.Lowerseatbrackets

4.ManualtubeR–clamp(2)

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3385-268*A

Summary of content (2 pages)

PAGE 1
Form No. 3385-268 Rev A Air Ride Seat Suspension Kit Reelmaster® 5010 Series Traction Unit Model No. 03667 Installation Instructions Installation 1. Position the machine on a level surface, lower the cutting units, stop the engine, engage the parking brake and remove the key from the ignition. 7. Remove the (4) bolts securing the seat suspension to the lower seat brackets (Figure 2). Retain the bolts and brackets for reuse. 2. Disconnect the negative battery cable from the battery.
PAGE 2
9. Mount the lower seat brackets to the seat base with the (4) bolts, spacers and nuts previously removed (Figure 2). 20. Install the access panel to the control arm (Figure 1). 21. Plug the traction unit power harness, from back of control arm into the seat harness connector. 10. Position the seat assembly onto the seat suspension. Make sure a washer is on each adjuster stud before placing it on the suspension (Figure 2). 22.