Service Manual

InstallingtheGearBoxAssembly(continued)
IMPORTANT
Thegroomergearboxinstalledontheleftsideofthecuttingunituse
aleft-handthread.Turntheinputshaft(rearrollerbrushdriveshaft)
counterclockwisetoinstallthegearbox.Thegroomergearbox
installedontherightsideofthecuttingunitusearight-handthread.
Turntheinputshaftclockwisetoinstallthegearbox.
g326056
Figure404
1.Squareheadsetscrew4.Reelshaft
2.Inputshaftassembly
5.Reelsupportplate
3.Gearboxassembly
6.Prybar
3. Insert a long-handled pry bar through the front of the cutting unit. The pry
bar should pass between the top of the reel shaft and the backs of the reel
blades so that the reel will not move.
4. Move the pry bar against the weld side of the reel support plate closest to
the gear box assembly and rest the handle of the pry bar against the front
roller.
5. Position the gear box assembly against the cutting unit and turn the drive
shaft assembly in correct direction until it is seated against the reel.
IMPORTANT
Youmustusea6-pointsocketwithaheavywalltoinstallthegear
boxtothereel.Donotuseanimpactwrench.Groomergearboxes
installedontheleftsideofthecuttingunitusealefthandthread;
turnthedriveshaftincorrectdirectiontoinstallthegearbox.
6.Tightentheinputshaftto136to149N·m(100to110ft-lb).
7.Removethesquareheadsetscrewfromtheendofthedriveshaft.
8.Useanewcotterpinandinstallthecotterpinandclevispinsecuringthe
heightadjustmentrodtothefrontofthegroomergearbox.
9.Installtherearrollerbrushdriveshieldifpreviouslyremoved.
Reelmaster
®
5410/5510/5610SeriesPage11–13UniversalGroomer(Optional):ServiceandRepairs
15216SLRevD