Operator's Manual

g019284
Figure9
1.Hoseguidesmustleantowardthecentercuttingunit.
Note:Wheninstallingorremovingthe
cuttingunits,makesurethehairpincotteris
installedinthespringrodholenexttothe
rodbracket.Otherwise,thehairpincotter
mustbeinstalledintheholeintheendof
therod.
6.Lowerallliftarmscompletely.
7.Removethelynchpinfromthelift-armpivot
yoke.Then,removethecap(Figure10).
g003975
Figure10
1.Lynchpin
2.Cap
8.Forthefrontcuttingunits,slideacuttingunit
undertheliftarmwhileinsertingthecarrier-frame
shaftupintothelift-arm-pivotyoke(Figure11).
g003977
Figure11
1.Liftarm3.Lift-arm-pivotyoke
2.Carrier-frameshaft
9.Usethefollowingprocedureontherearcutting
unitswhentheheightofcutisabove19mm
(3/4inch).
A.Removethelynchpinandwashersecuring
thelift-arm-pivotshafttotheliftarmand
slidethelift-arm-pivotshaftoutofthelift
arm(Figure12).
12