Service Bulletin

Toro Customer Bulletin LR #18-03 Page 10 of 14
2018 Universal Groomer Updates Reelmaster July 25, 2018
Updated Maintenance Instructions
Changing the Gearbox Lubricant
Service Interval
• After the first 100 hours
• Every 500 hours/yearly (whichever comes first)
1. Clean the external surfaces of the groomer housing.
Important: Ensure that there is no dirt or clippings on the outside of the groomer
housing. If debris gets inside of the groomer, it can damage the gearbox.
2. Remove the drain plug on the bottom of the housing. (Figure 3)
3. Remove the fill plug on the side of the housing and loosen the air vent plug on the top so air
can pass through. (Figure 3)
4. Align a suitable container beneath the oil drain port to catch the drained oil.
5. Tip the cutting unit vertically until the drain port is at the bottom to ensure complete drainage.
(Figure 1)
Figure 1
1. Drain plug 3. Air vent
2. Fill plug for the fill port
6. Remove the drain plug from the drain port. (Figure 1)
7. Remove the fill plug from the fill port. (Figure 1)
8. Loosen the air vent. (Figure 1)
9. Gently rock the cutting unit back and forth to ensure complete drainage. When the oil is
completely drained, place the cutting unit on a level surface.
Large Reels #18-03