Service Manual

Reelmaster 7000Hydraulic System Page 4 -- 100
Mow Control Manifold Service
1. Manifold body
2. Proportional valve (SP1 & SP2)
3. Solenoid coil (2 used)
4. Relief valve (RV1 & RV2)
5. Pressure compensator (LC1 & LC2)
6. Check valve (CV1 & CV2)
7. Nut
8. Backlap switch (2 used)
9. O--ring
10. Dowel
11. Ball
12. Retaining ring (2 used per spool)
13. Backup ring
14. O--ring
15. O--ring
16. Backup ring
17. Backlap spool (2 used)
18. Spool handle
Figure 74
60 in--lb
(6.8 N--m)
UP
25 ft--lb
(34 N--m)
2
3
6
8
9
10
11
13
1
5
7
12
14
15
16
17
18
4
2
3
6
8
12
15
12
15
16
15
17
18
25 ft--lb
(34 N--m)
25 ft--lb
(34 N--m)
25 ft--lb
(34 N--m)
20 ft--lb
(27 N--m)
25 ft--lb
(34 N--m)
25 ft--lb
(34 N--m)
NOTE: The ports on the manifold are marked for easy
identification of c omponents (e.g. P1 is a gear pump
connection port and PRV1 is the location for a propor-
tional relief valve). See Hydraulic Schematic in Chapter
9 -- Foldout Drawings to identify the function of the hy-
draulic lines and cartridge valves at each port location.
Cartridge Valve Service
1. For cartridge valve s ervice procedures, see Control
Manifold Cartridge Valve Service in this section. Refer
to Figure 74 for cartridge valve installation torque.