Service Manual

Reelmaster 7000−D (Model 03708)
DPA Cutting Units
Page 8 − 33
NOTE: The parallel position of the rear roller to the cut-
ting reel is controlled by the precision machined frame
and side plates of the cutting unit. If necessary, the cut-
ting unit side plates can be loosened and a slight adjust-
ment can be made to parallel the rear roller with the
cutting reel (see Leveling Rear Roller in this Chapter).
14.Install accessories if equipped. See Chapter 9 − Belt
Driven Groomer or Chapter 10 − Universal Groomer in
this manual for additional Groomer information. See
Rear Roller Brush in this chapter for information on rear
roller brush.
15.If counterweight was removed from cutting unit,
install new O−ring on counter weight. Secure counter
weight to cutting unit side plate with two (2) flange nuts.
Torque screws from 27 to 33 ft-lbs (37 to 44 N−m).
16.Install cutting unit to the machine.
DPA Cutting
Units