Service Manual

Reelmaster 7000−D (Model 03708)
DPA Cutting Units
Page 8 − 40
Roller Service (greasable bearings with retaining ring)
1. Roller tube (front Wiehle shown)
2. Roller shaft
3. Inner oil seal
4. Grease fitting
5. Ball bearing
6. Inner seal
7. Outer seal
8. Retaining ring
9. Outer oil seal
10. Roller washer
Figure 46
v
9
10
8
7
1
2
3
4
6
5
NOTE: Numerous front and rear rollers are available
for the Reelmaster cutting units. These rollers use one
of two styles of bearing and seal configurations. The first
design has retaining rings that secure the bearings and
seals in the roller (Fig. 46). The second design uses a
bearing lock nut to retain bearings and seals (Fig. 48).
Disassembly (Figs. 46 and 47)
1. Remove retaining ring from both ends of roller.
2. Support roller assembly and press one end of roller
shaft to remove seals and bearing from opposite end of
roller. Press on other end of roller shaft to remove re-
maining seals and bearing from roller. Be careful not to
drop roller shaft or tube when removing seals and bear-
ings.
3. Discard removed seals and bearings.
1. Roller tube
2. Roller shaft
3. Inner oil seal
4. Grease fitting
5. Ball bearing
6. Inner seal
7. Outer seal
8. Retaining ring
9. Outer oil seal
10. Roller washer
Figure 47