Operator's Manual

bedknife adjustment and height-of-cut adjustment.

2. Position the cutting units on a flat, level surface 25

mm thick piece of plywood).

3. Skids and front rollers used to prevent scalping

should not ride on the ground. Adjust each skid or

front roller so it is 3–6 mm or higher above the

level surface. Allow greater clearance at the higher

height-of-cut settings.

4. Proper adjustment is achieved when the cutting unit

does not scalp the grass in normal mowing condi-

tions and yet is set high enough not to mar the turf

and create undue wear on the skids or rollers.

Note: Skids are used only with the cutting unit in the

fixed position. Front rollers may be used with the cutting

unit in either the fixed or floating position.