Service Manual

Reelmaster 7000- D Hydraulic SystemPage 5 - 107
Installation (Fig. 63)
1. If fittings were removed from wheel motor, lubricate
and place new O- rings onto fittings. Install fittings into
motor ports using marks made during the removal pro-
cess to properly orientate fittings (Figs. 64 and 65).
Tighten fittings (see Hydraulic Fitting Installation in this
chapter).
2. Place new O- ring (item 16) into flange of wheel mo-
tor.
3. Position wheel motor to brake assembly.
4. Align splines on motor shaft and splined brake shaft.
Slide motor into brake assembly.
5. Secure motor to brake assembly with cap screws
and flat washers. Tighten cap screws from 75 to 85 ft-
lbs(101to115N-m).
6. Remove plugs from lines and fittings. Attach hydrau-
lic lines to wheel motor (see Hydraulic Hose and Tube
Installation in this chapter).
7. Lower machine to ground.
8. Fill reservoir with hydraulic fluid as required.
1. O- ring (2)
2. Straight fitting (2)
3. O- ring (2)
4. O- ring
5. Straight fitting
6. O- ring
7. O- ring (2)
8. Tee fitting
9. O- ring
Figure 64
2
3
6
8
9
1
5
7
4
3
2
7
LEFT WHEEL
FRONT
1. O- ring (4)
2. Tee fitting (2)
3. O- ring (2)
4. O- ring
5. Straight fitting
6. O- ring
7. O- ring
8. Straight fitting
9. O- ring
Figure 65
2
3
6
8
9
1
5
7
4
RIGHT WHEEL
1
3
1
2
FRONT
Hydraulic
System