Operator's Manual

Figure 12
1. Hour meter
Backlap Knobs
T he bac klap knobs ( Figure 13 ) are used in
conjunction with lo w er mo w/raise control lev er
for bac klapping operation. R efer to Bac klapping
in Cutting Unit Maintenance , pag e 48 .
Figure 13
1. Reel control knobs 2. Backlap knobs
Reel Speed Controls
Controls RPM of front and rear cutting units
( Figure 13 ). #1 position is for bac klapping .
R emaining settings are for mo wing operations . See
decal under seat for proper settings .
Seat
T he seat adjusting lev er ( Figure 14 ) allo ws 4 inc h
fore and aft adjustment. T he seat adjusting knob
( Figure 14 ) adjusts seat for operators w eight. T o
adjust seat fore and aft, pull lev er on left side
of seat assembly outw ard. After mo ving seat to
desired location, release lev er to loc k seat into
position. T o adjust for operators w eight, tur n
spring tension knob; cloc kwise to increase tension,
countercloc kwise to decrease spring tension.
Figure 14
1. Seat adjusting lever 2. Seat adjusting knob
Green Diagnostic Light
T he mac hine is equipped with a diagnostic light
whic h indicates if the electronic controller is
functioning cor rectly . T he g reen diagnostic light
( Figure 15 ) is located under the control panel,
next to the fuse bloc k. W hen the electronic
controller is functioning cor rectly and the k ey
switc h is mo v ed to the ON position, the controller
diagnostic light will be illuminated. T he light will
blink if the controller detects a malfunction in the
electrical system. T he light will stop blinking and
automatically reset when the k ey switc h is tur ned
to the OFF position.
Figure 15
1. Green diagnostic light
W hen the controller diagnostic light blinks , one of
the follo wing problems has been detected b y the
controller :
20