Operator's Manual

GREASING BEARINGS, BUSHINGS AND

PIVOT POINTS

Each cutting unit has (6) grease fittings (Fig. 15) that

must be lubricated regularly with No. 2 General Purpose

Lithium Base Grease.

Figure 15

The grease fitting locations shown in Figure 15 are for

each side of the cutting unit.

IMPORTANT: Lubricating cutting units immediately

after washing helps purge water out of bearings and

increases bearing life.

1. Wipe each grease fitting with a clean cloth.

2. Apply grease until pressure is felt against the

handle.

Note: Apply grease to reel bearing cavities until a

small amount is evident at the inboard reel seal.

3. Wipe excess grease away.

Lubrication