Operator's Manual

REEL CONSTRUCTION: Fairway reels. All welded. 5,

7 or 11 blades

HEIGHT OF CUT RANGE:

5 Blade: 19 mm to 38 mm

7 Blade: 12.7 mm to 28 mm

11 Blade:9.5 mm to 19 mm

Note: Use bedknife Part No. 93-9774 for heights of cut

below 12.7 mm.

REEL DIAMETER: 17.7 mm

POWER: Reel motors feature quick disconnect for

removal or installation onto the cutting unit. Cutting

units can be driven from either end.

HEIGHT-OF-CUT & ROLLER ADJUSTMENT: Height-

of-cut adjustment is made at the rear roller with the

quick locating pin and/or threaded micro-adjustment.

The front roller position is adjustable, for setting unit

attitude.

BEDKNIFE AND BEDBAR ADJUSTMENT: Single-

point adjustment mechanism.

CLIP FREQUENCY: .9.5 mm—31.7mm. Reel speed

automatically adjusts to maintain proper clip. Reel

speed is continuously calculated based on the current

forward speed, reel type (number of blades) and height

of cut.

ROLLERS:

Front rollers: 7.62 cm diameter Wiehle rollers. Optional

7.62 cm diameter full rollers, Part No. 93-3040, are

available for the front position.

Rear rollers: 6.35 cm diameter full rollers. All rollers

use the same heavy-duty ball bearings with two

conventional single lip seals and a Toro labyrinth seal to

provide four sealing surfaces to protect the bearings.

ROLLER SCRAPER KITS:

Front Roller Scraper Part No. 95-7729

Rear Roller Scraper Kit Part No. 98-7996 (1 per kit)

Specifications