Operator's Manual

5
Desired Height
of Cut
Rear Support Hole Rear Cutting Unit Side Plate Hole
••
Rear Thread
Distance “R”
••
Front Roller
Thread
Distance “F”
Upper Lower 1 2 3 4 5 6
*9.5 mm X X 13.5 mm 13.9 mm
*12.7 mm X X 14.2 mm 9.1 mm
15.9 mm X X 17.5 mm 6.1 mm
19.0 mm X X 13.7 mm 2.8 mm
22.2 mm X X 17.0 mm 0.0 mm
25.4 mm X X 13.2 mm –3.6 mm
28.6 mm X X 16.5 mm –6.6 mm
31.8 mm X X 12.9 mm –9.7 mm
34.9 mm X X 16.0 mm –12.9 mm
38.1 mm X X 12.5 mm –16.3 mm
*Optional low-cut bedknife (Part No. 93-9774) is required for height of cut below 12.7 mm).
**Rear thread distance is 4.8 mm shorter for initial set-up.
Rear Bracket Distance = R
Figure 5
1. Height-of -cut adjusting capscrew
2. Height-of-cut support
3. Quick height-of-cut pin
4. Roller bracket
Quick Height-Of-Cut Pin Holes
Figure 6
1. Side plate
2. Height-of -cut support
3. Upper hole
4. Lower hole
Front Bracket Distance = F
Figure 7