Operator's Manual

ADJUSTING CUTTING UNIT

ATTITUDE

(2-SCREW GAUGE BAR)

The cutting unit attitude may be adjusted or verified

using a gauge bar, Toro part no. 98-1852, which has two

screws and three hole locations. The second screw is

used in the inner hole to set or verify cutting attitude.

Adjust as follows:

1. Set the front screw height to the final height-of-cut

setting (Fig. 12).

2. Set the rear screw, distance “B”, lower than the

front setting (Fig. 12).

.20” (5.3mm) 8

.15” (3.8mm) 6

.09” (2.3mm) 4

.04” (1.0mm) 2

Figure 12

1. Adjust for final height-of-cut setting

3. Place a gauge bar across front and rear rollers. The

front screw head should fit snugly over the edge of

the bedknife and the end of the rear screw should

contact the bottom of the bedknife (Fig. 13 & 14).

Front and rear rollers should contact the gauge bar.

Verify attitude at each end.

Figure 13

1. Bedknife

Figure 14