Operator's Manual

Setting Height-of-Cut

Note: If leveling the front roller causes the

cutting unit attitude to be different

from side to side by more than one

degree, you may need to regrind the

reel and/or bedknife to eliminate

uneven wear.

Figure 12

D. Finalizing Height-of-Cut

1. Rotate the cutting unit vertical and place the

gauge bar across front and rear rollers (Fig. 13).

2. Adjust rear roller until it contacts the gauge bar

on both sides (Fig. 13).

Figure 13

1. First screw

2. Second screw

3. Adjust rear roller

Note: Make sure gauge bar is in contact with

the front roller at all times to keep

desired height-of-cut.

3. Slide gauge bar toward the end of the cutting

unit to remove. Gauge bar can now be utilized to

set remaining cutting units on machine.