Operator's Manual

Thank you for purchasing a Toro product.
All of us at Toro want you to be completely satisfied
with your new product, so feel free to contact your
local Authorized Service Dealer for help with
service, genuine Toro replacement parts, or other
information you may require.
Whenever you contact your Authorized Service
Dealer or the factory, always know the model and
serial numbers of your product. These numbers will
help the Service Dealer or Service Representative
provide exact information about your specific
product. You will find the model and serial number
plate located in a unique place on the product as
shown below.
1. Model and Serial Number Plate
For your convenience, write the product model and
serial numbers in the space below.
Read this manual carefully to learn how to operate
and maintain your product correctly. Reading this
manual will help you and others avoid personal
injury and damage to the product. Although Toro
designs, produces and markets safe, state-of-the-art
products, you are responsible for using the product
properly and safely. You are also responsible for
training persons who you allow to use the product
about safe operation.
The Toro warning system in this manual identifies
potential hazards and has special safety messages
that help you and others avoid personal injury, even
death. DANGER, WARNING and CAUTION are
signal words used to identify the level of hazard.
However, regardless of the hazard, be extremely
careful.
DANGER signals an extreme hazard that will cause
serious injury or death if the recommended
precautions are not followed.
WARNING signals a hazard that may cause serious
injury or death if the recommended precautions are
not followed.
CAUTION signals a hazard that may cause minor
or moderate injury if the recommended precautions
are not followed.
Two other words are also used to highlight
information. "Important" calls attention to special
mechanical information and "Note" emphasizes
general information worthy of special attention.
The left and right side of the cutting unit is
determined by standing with the rear roller nearest
you.
Introduction
Model No:_________________________
Serial No.:_________________________
The Toro Company—1999
All Rights Reserved