Operator's Manual

CuttingUnitMaintenance
SeparatingtheCuttingUnit
fromtheTractionUnit
1.Placethemoweronitsdrumsonalevelsurface.
2.Lowerkickstand.Inserta1/4"dia.pinorequivalent
intoframeholeabovekickstandmountingbolt
(Figure47).
Figure47
1.1/4"Pin
3.Kickstand
2.Handle
3.Removegrassbasket.
4.Remove(2)boltssecuringcuttingunitpivotarmsto
tractionunitframetube(Figure48).
Figure48
1.Cuttingunitpivotarms
3.Bolts
2.Tractionunitframetube
5.Rotatepivotarmsforward(Figure48)andrest
tractionunitonrestrainedkickstand.
6.Pullcuttingunitforwardabout2inch(51mm)
andthentotherighttodisengagethetransmission
coupling(Figure49).
Figure49
1.Transmissioncoupling
7.Reverseproceduretoinstallcuttingunit.
Note:Whentighteningthepivotarmmounting
fasteners,useanadjustableendwrenchtoholdthe
pivotarmparalleltothesideplate(Figure50).
Figure50
AdjustingtheRearRoller
1.Adjusttherearrollerbracketstotheloworhigh
positiondependingondesiredheightofcutrange
(Figure51andFigure52).
•Positionthespacerabovethesideplatemounting
ange(factorysetting)whenheightofcut
settingsrangefrom1/16to1/4"(Fig.10).
31