Service Manual
Table Of Contents
- Preface
- Table Of Contents
- 1 - Safety
- 2 - Product Records and Maintenance
- 3 - Engine
- Kawasaki FE120 Engine Service Manual
- 4 - Traction and Reel Drive System
- 5 - Electrical System
- 6 - Chassis and Controls
- 7 - Cutting Unit
- 8 - Groomer
Greensmaster Flex 18/21 Traction and Reel Drive SystemPage 4 – 23
Assembly (Fig. 31)
1. Insert RH (short) axle into input gear/housing on the
gear side. Install washer, drive bevel gear and new re-
taining ring on short axle. Install LH (long) axle into re-
maining side of input gear/housing using the same
procedure.
2. Through the open sides of the input gear/housing,
align two driven bevel gears and rotate axle to move
them into their correct position.
3. Place a washer between input gear/housing and
each driven bevel gear. Install gear shaft with grooved
end located at roll pin hole.
4. Check gear and shaft alignment by rotating one axle.
The other axle should turn in the opposite direction with-
out any binding. Once free axle movement is checked,
install new roll pin to secure gear shaft.
5. Install differential assembly in gearbox and as-
semble gearbox (see Gearbox Assembly). Install gear-
box to traction unit (see Gearbox Installation).
Traction and Reel
Drive System