Service Manual

Greensmaster Flex 18/21Page 5 – 8Electrical System
Service and Repairs
NOTE: See the Kawasaki FE120 Service Manual at
the end of Chapter 3 – Engine for additional repair in-
formation.
Interlock Switch
Adjustment
1. Make sure the engine is OFF and the traction lever
is in the NEUTRAL position.
2. Loosen interlock switch mounting fasteners.
3. Hold traction lever against the neutral stop (Fig. 6).
4. Position switch to allow from 0.032“ to 0.062” (0.81
to 1.58 mm) clearance between the traction lever and
the interlock switch (Fig. 6).
5. Tighten interlock switch mounting fasteners. Re-
check clearance between lever and switch after tighten-
ing fasteners. The traction lever must not contact the
switch.
6. Engage traction lever and verify that the switch
opens (no continuity).
Removal
1. Disconnect switch from the wires leading from the In-
terlock module.
2. Remove fasteners and spacers that mount switch to
control bracket on handle (Fig. 7). Remove switch from
bracket.
Installation
1. Position switch to control bracket with fasteners and
spacers (Fig. 7).
2. Adjust interlock switch (see Adjustment above) as
necessary. Make sure that lock nuts are securely tight-
ened after adjustment.
3. Connect switch to wires from the interlock module.
1. Traction lever
2. Neutral stop
3. Interlock switch
4. Clearance
Figure 6
3
1
2
4
1. Interlock switch
2. Control bracket
3. Handle
4. Cap screw (2 used)
5. Spacer (2 used)
6. Lock nut (2 used)
7. Console
Figure 7
5
3
1
2
6
4
7