Service Manual

Greensmaster Flex 18/21Page 6 – 12Chassis and Controls
Kickstand
1. Kickstand
2. Cap screw
3. Flat washer
4. Long spacer
5. Torsion spring
6. Cap screw
7. Spacer
8. Flange nut
9. Cap screw
10. Support bushing
11. Cap screw
12. Frame assembly
Figure 16
8
9
10
10
8
4
3
2
6
3
8
10
11
7
1
5
FRONT
RIGHT
8
12
Removal (Fig. 16)
1. Park machine on a level surface. Make sure the en-
gine is OFF.
2. Pivot kickstand up and hold against the frame stops.
CAUTION
Be careful when removing or applying tension
from or to the torsion spring of the kickstand.
The spring is under heavy load and may cause
personal injury.
3. Use a nutdriver or small diameter pipe over the end
of the torsion spring. Push the torsion spring down and
in to release spring tension (Fig. 17).
4. Remove flange nuts, cap screws, flat washers,
spacers and torsion spring from the kickstand and
frame. Note that long spacer and torsion spring is on the
left side of the machine and short spacer is on the right.
5. Remove kickstand from the frame.
Installation (Fig. 16)
1. Make sure machine is parked on a level surface and
the engine is OFF.
2. Position kickstand inside the machine frame. Insert
cap screws through the washers, kickstand, spacers
and frame (Fig. 16).
3. Secure cap screws with flange nuts. Tighten fasten-
ers.
4. Pivot kickstand up and hold against the frame stops.
Use a nutdriver or small diameter pipe over the end of
the torsion spring. Push the spring end down and out to
install spring (Fig. 17).
1. Kickstand
2. Torsion spring
3. Torsion spring end
Figure 17
1
2
3