Installation Instructions

ManualsBrandsToro ManualsAttachmentsLight Kit, 2008 and Later Walk-Behind Greensmaster Mowers

FormNo.3360-173RevA

LightKit

2008andlaterGreensmaster

WalkBehingMowers

ModelNo.04061

InstallationInstructions

Beforeservicingormakingadjustmentstothemachine,stopengineandremovethewirefromthe

sparkplug.

InstallingtheLights

ForGreensmasterFlex18

1.Aligntheinnersetoflightbracketmountingholes

withthehandle.Thelightbracketshouldextend

outwardfromthehandle(Figure1).

Figure1

1.Lightbracket2.Light

2.Looselysecurethelightbrackettothehandlewitha

clampandtwonyloninsertlocknuts(Figure1).

3.Positionthelightbracketapproximately6"below

theconsole.

4.Tightenthetwonyloninsertlocknuts(Figure1).

5.Usingtheoutermountingholeinthelightbracket,

mountthelighttothebracketwithacarriagebolt,

lockwasherandnut(Figure1).

ForGreensmasterFlex21,

Greensmaster1000,Greensmaster

1600,Greensmaster2000and

Greensmaster2600

1.Aligntheoutersetoflightbracketmountingholes

withthehandle.Thelightbracketshouldextend

inwardfromthehandle(Figure2).

Figure2

1.Lightbracket2.Light

2.Looselysecurethelightbrackettothehandlewitha

clampandtwonyloninsertlocknuts(Figure2).

3.Positionthelightbracketapproximately6"below

theconsole.

4.Tightenthetwonyloninsertlocknuts(Figure2).

5.Usingtheoutermountingholeinthelightbracket,

mountthelighttothebracketwithacarriagebolt,

lockwasherandnut(Figure2).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (2 pages)

PAGE 1
Form No. 3360-173 Rev A Light Kit 2008 and later Greensmaster® Walk Behing Mowers Model No. 04061 Installation Instructions Before servicing or making adjustments to the machine, stop engine and remove the wire from the spark plug. Installing the Lights For Greensmaster Flex 18 1. Align the inner set of light bracket mounting holes with the handle. The light bracket should extend outward from the handle (Figure 1).
PAGE 2
Connecting the Lights 5. Mount the voltage regulator strap, voltage regulator ground wire ring terminal and the harness ground wire ring terminal to the engine boss with a external tooth lockwasher and capscrew (Figure 5). Use the right hand boss. 1. Remove the plug from the hole in the top of the console (Figure 3). 6. Feed the engine wires and the voltage regulator wires through the R-clamp (Figure 5). 7. Secure the wire harness to the handle using the nylon cable ties.