Operator's Manual

2
3
2
1
1
Figure 2
1. Capscrews
2. Shim
3. Reel bearing locknut
Note: To ease assembly, lubricate the inside diameter of
the oil seal with oil or grease (Fig. 3).
1
Figure 3
1. Oil seal
9. Position the right-hand groomer drive assembly onto
the capscrews (Fig. 4).
1
2
2
Figure 4
1. Right hand groomer drive
assembly
2. Nuts
10. Secure the groomer drive assembly to the capscrews
with (2) nuts (Fig. 4). Tighten the capscrews and nuts.
11. Lubricate the outside of the groomer drive pulley with
oil or grease. Do not put oil or grease on the area
where the belt will ride.
12. Install the groomer drive pulley onto the reel shaft
(Fig. 5).
Note: The pulley has left-hand threads.
1
Figure 5
1. Groomer drive pulley
13. Remove and discard the large flat washers shipped on
each end of the grooming reel or brush shaft (Fig. 6).
1
Figure 6
1. Large flat washer for
shipping (2)
14. Apply grease to seal in drive assembly bearing support
and to end of groomer shaft (Fig. 7).
15. Slide one end of the grooming reel or brush shaft into
the bearing support in the groomer housing assembly
(Fig. 7). Support the shaft to reduce misalignment
through the bearings.
2
1
Figure 7
1. Grooming reel shaft 2. Bearing support