Operator's Manual

Note:Determinetheleftandrightsidesofthemachine
fromthenormaloperatingposition.
Note:Toinstalltheweightrodontoyourmachine,referto
theinstallationinstructionsinyourCuttingUnitOperator’s
Manual.
1
InstallingtheTargetPlate
Partsneededforthisprocedure:
1Targetplate
Procedure
1.Setupandpreparethecuttingunitasdescribedinthe
cuttingunitOperator’sManual.
2.Removethecenter,grass-shieldbolt(Figure3).
3.Installthetargetplatetothetopofthecuttingunit
usingtheboltthatyouremovedpreviously(Figure3).
1
2
G017294
Figure3
1.Center,grass-shieldbolt
2.Targetplate
2
InstallingtheCuttingUnitto
theTractionUnit
Partsneededforthisprocedure:
2
Bolt(3/8x3/4inch)
Procedure
Note:Toinstalltheweightrodontoyourmachine,referto
theinstallationinstructionsinyourCuttingUnitOperator’s
Manual.
1.Placethemoweronitsdrumsonalevelsurface.
2.Lowerthekickstandandpushinthelockingpinto
lockthekickstandintheserviceposition(Figure4).
Note:Allowthemachinetorestonthelocked
kickstand.
Note:Placethekickstandinthispositionwhenever
youremovethereel.Thiswillkeepthemachinefrom
tippingbackwardontothehandle.
G017356
1
2
3
Figure4
1.Kickstand—storage
position
3.Kickstand—service
position
2.Lockingpin
3.Pushthecuttingunitunderthetractionunitandtothe
lefttoengagethetransmissioncoupling(Figure5).
11