Operator's Manual

G017237
1
2
Figure13
1.T-handleconnector2.Mainpowersupply
connectoronthebattery
platform
16.Chargethebatteryasdescribedintheinstructionsthat
camewiththebatterycharger.
Note:Thebatteryisshippedwithapartialcharge
(approximately40%).Thisisenoughchargeforyouto
performfunctionalchecksonthemachineandmove
itasneededtocompletesetup,butyoushouldfully
chargethebatterybeforeusingthemachine.
5
AdjustingtheEZ-TurnSensor
NoPartsRequired
Procedure
1.Ensurethattheunitisonaat,levelsurfacewiththe
tractiondrumontheground.
2.Loosenthejamnutsonthesensorandadjustthe
sensorsothat1threadisvisiblepastthelowerjamnut
(Figure14).
1
2
3
4
5
6
7
G0172357
8
Figure14
1.Sensorlight(ontop)5.1-1/2inches(3.8cm)block
2.Jamnuts6.Targetplate
3.EZ-Turnsensor
7.Bracketfasteners
4.Roller
8.Sensorbracket
3.Tightenthejamnutstosecurethesensor.
4.Placea3.8cm(1-1/2inches)blockunderthefront
cuttingunitroller(Figure14).
5.Loosenthefastenerssecuringthesensorbracketto
theframe(Figure14).
6.Turnonthemachine;refertoTurningontheMachine
(page22).
7.SettheEZ-TurnswitchtotheOnposition;referto
EZ-TurnSwitch(page18).
8.Rotatethesensorbrackettowardthetargetplateuntil
thelightontopofthesensorilluminates(Figure14).If
itwasalreadyilluminated,rotateitawayfromthetarget
plateuntilitgoesoutandthenreversedirectionjust
untilitilluminatesagain.
9.Tightenthebracketfasteners.
10.Removetheblockfromundertherollerandplacethe
machineonthekickstand.
11.Ensurethatthetargetplatedoesnotcontactthegrass
shield.
Note:Ifitdoes,loosenthebracketfastenersand
rotatetheswitchupjustuntilthetargetplateisno
longertouchingthegrassshield.
12.Turnoffthemachine.
15