Installation Instructions

ManualsBrandsToro ManualsAttachmentsTrans Pro 100 Tow-Behind Trailer

FormNo.3422-550RevA

TransPro100Tow-BehindTrailer

ModelNo.04240—SerialNo.402990001andUp

InstallationInstructions

Safety

SafetyandInstructionalDecals

Safetydecalsandinstructionsareeasilyvisibletotheoperatorandarelocatednearanyarea

ofpotentialdanger.Replaceanydecalthatisdamagedormissing.

decal98-8688

98-8688

1.Warning—donotdrivethevehiclewithatrailerdownahill;do

notlosecontrolofthevehicleandtrailer.

3.Warning—donotexceed24km/h(15mph).

2.Warning—donotcarrypassengers.

4.Warning—readtheOperator’sManual;themaximumtrailer

weightis227kg(500lb)andthemaximumtongueweightis

25kg(55lb).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3422-550*A

Summary of content (8 pages)

PAGE 1
Form No. 3422-550 Rev A Trans Pro 100 Tow-Behind Trailer Model No. 04240—Serial No. 402990001 and Up Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal98-8688 98-8688 1. Warning—do not drive the vehicle with a trailer down a hill; do 3. Warning—do not exceed 24 km/h (15 mph). not lose control of the vehicle and trailer. 2.
PAGE 2
Installation Assembling the Trailer 1. decal98-8687 98-8687 1. The trailer tires should be inflated to 0.35 bar (5 psi); read the Operator’s Manual. Mount the tongue assembly to the mounting bracket on the underside of the trailer bed with 2 bolts (3/8 x 2-3/4 inches) and 2 locknuts (Figure 1). decal98-8676 98-8676 1. Warning—do not climb the ramp, you could slip and fall. g233569 Figure 1 1. Tongue assembly 3. Wheel rod 2. Trailer bed 4. Stop decal133-8061 133-8061 2.
PAGE 3
5. Adjusting the Wheel Toe-in Mount the trailer ramp to the rear of the trailer bed with the hinge rod and 2 cotter pins (Figure 3). To prevent premature wear of the tires, the wheels should have 0 to 3 mm (0 to 1/8 inch) toe-in. Note: Apply a light coating of grease to the hinge rod prior to assembly. Adjust the wheel-toe in as follows: 1. Draw a line around the center of each tire. 2. Measure the center-to-center distance at the wheel hub height, at the front and rear of the tires (Figure 4).
PAGE 4
Loading the Trailer Operation 1. Unhook the ramp latch from the wheel guide and lower the ramp to ground. 2. Pivot the first set of wheel rods upward. 3. Remove the baskets from the machine to be towed and disengage the reel drive. 4. Move the throttle to the slowest position and slowly drive the machine onto the trailer until the transport wheels contact the trailer stops (Figure 1). 5.
PAGE 5
Operating Tips • Ensure that the trailer is properly connected to the tow vehicle before loading or unloading the machines to prevent the tongue from suddenly moving or flipping up. • The trailer adds extra towing weight to the vehicle. Drive the vehicle safely. – Do not drive the machine on highways or public roads. – Always slow the tow vehicle when approaching and while making a turn. – Always slow the tow vehicle when driving in unfamiliar areas or over rough terrain.
PAGE 6
European Privacy Notice The Information Toro Collects Toro Warranty Company (Toro) respects your privacy. In order to process your warranty claim and contact you in the event of a product recall, we ask you to share certain personal information with us, either directly or through your local Toro company or dealer. The Toro warranty system is hosted on servers located within the United States where privacy law may not provide the same protection as applies in your country.
PAGE 7
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.
PAGE 8
The Toro Warranty A Two-Year Limited Warranty Conditions and Products Covered The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first. This warranty is applicable to all products with the exception of Aerators (refer to separate warranty statements for these products).