Installation Instructions

1
All Rights Reserved
Printed in the USA
W 1998, 2003 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Tow Behind Trailer
TransPro 100
Model No. 04240–250000001 & Up
Form No. 3321–481 Rev D
Installation Instructions
Assembly
1. Mount tongue assembly to mounting bracket on
underside of trailer bed with (2) 3/8–16 x 2–3/4” lg.
capscrews, spacers, and lock nuts. For most
applications, use front set of mounting holes in tongue
and bracket (Fig. 1).
1
4
3
2
Figure 1
1. Tongue assembly
2. Trailer bed
3. Wheel rod
4. Stop
2. Mount a axle to mounting bracket on each side of trailer
bed with (4) carriage bolts and locknuts (Fig. 2).
1
3
2
Figure 2
1. Axle
2. Mounting bracket
3. Wheel assembly
3. Mount a wheel assembly to each axle hub with (4) lug
nuts (Fig. 2). Tighten nut to 80 ft/lb. Inflate tires to
5 psi.
Note: To prevent premature wear of the tires, the wheels
should have 0 to 1/8” toe–in when they are pointed straight
ahead. To check toe–in, scribe a line around center of each
tire. Measure center to center distance (Fig. 3), at wheel
hub height, in front and back of the tires. If toe–in is not
within 1/8”, adjust axle mounting brackets as required.
Front
center to center
distance
Rear
center to center
distance
Figure 3
Important Higher tire pressure may cause damage to
greens mower.
4. Mount trailer ramp to rear of trailer bed with hinge rod
and (2) cotter pins (Fig. 4).
Note: Apply a light coating of grease to hinge rod prior to
assembly.
4
2
1
3
Figure 4
1. Trailer ramp
2. Hinge rod
3. Ramp latch
4. Wheel guide
5. Pivot trailer ramp upward hook ramp latch into hole in
top of wheel guide (Fig. 4).