Installation Instructions

ManualsBrandsToro ManualsAttachmentsRail Ramp Conversion Kit, Trans Pro 100 Tow-Behind Trailer

FormNo.3415-587RevA

RailRampConversionKit

TransPro100Tow-BehindTrailer

ModelNo.04248

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Lefttubeassembly

Righttubeassembly1

Carriagebolt

Flatwasher8

Locknut8

Loadramp2

Spacer

Hex-headscrew2

Rubbertube2

Nut2

Lockingbracket2

Bracketscrew4

Bracketnut4

Narrowwheelrod4

Capscrew(formodelspriortoserial

#220000001)

Installtherailsandramps.

Feltseal2

Railwheel4

Wheelclip4

Installtherailwheels.

Nopartsrequired

–

Loadthemachine.

InstallingtheRailsand

Ramps

1.Raiseandsecurethetrailer.

2.Removethe4lugnutssecuringthetiresand

removethetirestoaccessthewheelrods.

3.Ifequipped,removethefastenerssecuringthe

standardinsertstothebottomoftherampand

removetheinserts(Figure1).

g235575

Figure1

1.Trailerstop3.Wheelrod

2.Standardinsert

4.Brackets

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3415-587*A

Summary of content (4 pages)

PAGE 1
Form No. 3415-587 Rev A Rail Ramp Conversion Kit Trans Pro 100 Tow-Behind Trailer Model No. 04248 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty.
PAGE 2
4. Note: On trailers with serial numbers prior Remove the existing trailer stops, wheel rods, and brackets from the trailer (Figure 1). to 220000001: all tube assembly mounting holes are not in the sides of the trailer and will have to mounted as follows: Note: Save the trailer stops, brackets, and hardware for later installation. 5.
PAGE 3
9. Loosely mount each locking bracket to the ramp with 5/16 x 3/4 inch flange head screws and flange nuts (Figure 2 and Figure 4). Note: If the ramp handle interferes with the mounting fastener of the locking bracket, grind off the end of the handle to expose the hole, as required (Figure 3). Touch up the paint. g017124 Figure 4 1. Locking bracket 3. Ramp 2. Load ramps 11. g017123 Figure 3 1. Ramp handle 10.
PAGE 4
Installing the Rail Wheels 1. Remove the existing standard transport wheels from the wheel shafts on the greensmower (if equipped). 2. On the Greensmaster Flex 18 or 21 machines only, proceed as follows: • Remove the right side drum cover from the g014669 machine (Figure 5). Figure 6 1. Wheel shaft 3. Wheel clip 2. Rail wheel Loading the Machine Lower the load ramps, roll the machines onto the rails, and secure the wheels in the wheel stops (Figure 7). g017122 Figure 5 1.