Operator's Manual

ManualsBrandsToro ManualsRiding ProductsGreensmaster 3250-D

8. Mount the basket onto the carrier frame.

9. Adjust the pull links until there is 1/16 to 1/8 in. (2 to

3 mm) clearance between the lip of the basket and the

reel blades. Make sure the basket lips are equidistant

from the reel blades all the way across the reel blades.

10. Assemble the mounting screws for the reel drive motor

to each cutting unit. Leave approximately 1/2 in.

(13 mm) of the threads exposed on each mounting

screw (Fig. 19).

Figure 19

1. Screws 2. Drive motor

11. Remove the protective covers from the cutting units and

the reel drive motor shafts.

Note: Retain the protective covers for the cutting units.

Install them whenever the reel drive motors are removed to

protect the cutting unit bearings from contamination.

12. Coat the spline shaft of the motor with clean grease and

install the motor by rotating the motor clockwise so the

motor flanges clear the studs. Rotate the motor

counterclockwise until the flanges are encircling the

studs and tighten the mounting capscrews (Fig. 19).

13. Using a hand pump grease gun, fill the cavity at the end

of the cutting unit with #2 general purpose grease.

Adjusting the Transport Height

Check the transport height (Fig. 20 & 22) and adjust, if

required.

1. Position the tractor on a level surface.

2. On cutting units equipped with a chain link or a straight

lift hook (Fig. 20 & 21, insets) verify that the distance

from the top of the carrier frame adjusting screw to the

back of the carrier frame is 7/8 inch (22 mm). If the

distance is not 7/8 inch (22 mm), proceed to step 4. If

the cutting unit is equipped with an offset lift link

(Fig. 22), proceed to the next step.

Right Front Shown

7/8 in.

(22 mm)

Figure 20

1. Transport plate

2. Adjusting screw

3. Transport plate mounting

screw

4. Chain link