Operator's Manual
! !
6.. .+0- #44'/$.:
6.. .+0- '95'04+10
#.. ,1+05 3'%'+7'3
:.10 $64*+0)
2#%'3
"#4*'3
+)63'
Make sure all tires are inflated to 8-12 p.s.i.
!
+)
Position traction unit on a level surface and lower
cutting unit carrier frames to the floor.
Verify that there is 1/2" clearance between carrier
frame rollers and floor.
If an adjustment is required, loosen jam nut on
carrier frame stop screw (Fig. 8) and rotate screw up or
down to raise or lower carrier frame. Tighten jam nut
after adjustment is attained.
#33+'3 (3#/' 31..'3
#33+'3 (3#/' 4512 4%3'8
+)*5 3105 *180
+)63'
15' If you are using a GREENSMASTER 3250-D in
hot climates, where ambient temperatures range from
70F (20C) to 120F (49C), or using it for heavyĆduty
use (mowing other than greens, such as fairways or
verticutting), TORO strongly recommends installation
of an hydraulic Oil Cooler Kit, Part No. 100-3166, to the
traction unit.
! ! +)
15' When sharpening, setting heightĆofĆcut, or
performing other maintenance procedures on the
cutting units, store the cutting unit reel motors in
support tubes on front of frame to prevent damage to
the hoses.
!
1 015 3#+4' 4642'04+10 51 53#042135
214+5+10 8*'0 5*' 3''. /15134 #3' +0 5*'
*1.&'34 +0 5*' 53#%5+10 60+5 (3#/' #/;
#)' 51 5*' /15134 13 *14'4 %16.& 3'46.5
Remove cutting units from cartons. Assemble and
adjust per the Operator's Manual for the cutting units.
Use the Height Gauge bar from Loose Parts Kit to
adjust height of cut.
15' All cutting units are shipped with the counter
weight mounted to left end and drive coupler mounted
in the right end of cutting unit. To mount the cutting unit
in the right front position, proceed as follows:
A. Remove (2) capscrews and lockwashers
securing counter weight to left end of cutting unit.
Remove counter weight (Fig. 9, inset).
B. Remove snap ring securing drive coupler in
right bearing housing. Remove drive coupler.
C. Apply grease to I.D. of drive coupler. Install
drive coupler to left end of cutting unit with snap
ring.
D. Install counter weight to right end of cutting
unit with capscrews and lockwashers.
1605'3 8'+)*5
0#2 3+0)
3+7' %162.'3
+)63'