Operator's Manual
-1# If installing Greensmaster 3200 cutting units with
serial numbers ranging from 50001 through 99999,
proceed as follows:
A. Remove and discard front shield assembly
(Fig. 10). Also, remove and discard shield
mounting studs and fasteners secured to each
cutting unit side plate.
B. Remove the single point pull arm from the front
roller and discard.
C. Bend grass shield side deflectors outward until
flush with cutting unit side plates.
/-,1 0&'#*" 00#+ *6
/-,1 0&'#*" +-2,1',% 012"0
/00 0&'#*" 0'"# "#$*#!1-/0
'%2/#
Thread a ball stud into each end of cutting unit front
roller (Fig. 12).
Slide the cutting unit under the pull frame while
hooking the hoop onto lift arm. To facilitate installation
of the rear cutting unit, the pull frame can be rotated
and latched into a service position:
A. Lower the suspension system completely
(cylinders extended).
B. Lift the carrier frame by hand until the
antiĆscalp rollers clear the brake linkage.
C. Lift up on the slotted link and rotate the pull
frame into the wire hook (Fig. 11).
D. With the cutting unit in position, release the
wire hook and rotate the pull frame to operating
position. The slotted link locks automatically.
E. Attach motor and pull links.
- ,-1 -.#/1# 1&# *'$1 0601#+ 4&#, 1&#
!#,1#/ !211',% 2,'1 '0 ', 1&# 0#/3'!#
.-0'1'-, +%# !-2*" /#02*1 1- 1&# .2**
$/+# ," !*#3'0 00#+ *6
'%2/#
*-11#" *',)
'/# &--)
-1# When installing cutting units with groomers, and
groomer carton label does not read with extension
brackets," Groomer Extension Kit, part no. 99-4255, is
required.
Slide sleeve back on each ball joint receiver and
hook onto cutting unit ball studs (Fig. 12).
** 012"
2** /+ #51#,0'-,
** (-',1 /#!#'3#/
4- %/--+#/
'%2/#
-1# Pull link assemblies are preset at the factory. If
they ever need to be disassembled, reassemble to the
dimensions shown in figure 12.
Mount basket onto carrier frame.
Adjust pull links until there is 1/4" to 3/8" clearance
between the lip of the basket and the reel blades. Make
sure the basket lips are equidistant from the reel blades
all the way across the reel blades.