Operator's Manual
"
The cooling system is filled with a 50/50 solution of
water and permanent ethylene glycol anti-freeze.
Check level of coolant at beginning of each day before
starting the engine.
#"
+ *2,.2* -&6 '**2 5822.2, 45*6685.<*)
-37 (330&27 (&2 *6(&4* :-*2 5&).&735
(&4 .6 5*139*) &2) (&86* '8526
Park machine on a level surface.
Check coolant level. Coolant should be between
lines on reserve tank, when engine is cold.
If coolant is low, remove reserve tank cap and add
a 50/50 mixture of water and permanent ethylene
glycol anti-freeze. " $ .
Install reserve tank cap.
.,85*
*6*59* 7&2/
% # !%!" #
.,
The hydraulic system is designed to operate on
antiĆwear hydraulic fluid. The machine's reservoir is
filled at the factory with approximately 5.5 gallons
(20.8 L) of Mobil DTE 15M hydraulic fluid. -*(/ 0*9*0
3+ -;)5&80.( +08.) '*+35* *2,.2* .6 +.567 67&57*) &2)
)&.0; 7-*5*&+7*5 Appropriate hydraulic oils are listed
below.
5384 ;)5&80.( 08.) 3)*5&7* (0.1&7*
&9*5&,* )87;
37* The fluids within this group are interchangeable.
! $ 1807.=9.6(36.7; &27.=:*&5
-;)5&80.( +08.)
Mobil DTE 15M
Amoco Rykon Premium ISO 46
Castrol AWH 46
Conoco Hydroclear AW MV46
Gulf Harmony HVI 46 AW
Kendall Hyken Golden MV SAE 5WĆ20
Pennzbell AWX MV46
Phillips Magnus A KV 5WĆ20
Shell Tellus T 46
Sunoco Sun Hyd. Oil 2105
Texaco Rando HDZ 46
#2.9*56&0 "5&(735 ;)5&80.( 08.)
Mobil Mobilfluid 424
Amoco 1000 Fluid
Chevron Tractor Hydraulic Fluid
Conoco Hydroclear Powertran
Esso Hydraul
Gulf Universal Tractor Fluid
Kendall Hyken 052
Marathon Marafluid Super HT
Pennzoil HydraĆtrans
Phillips HG Fluid
Shell Donax TD
76 Lubricants Hydraulic/Tractor Fluid
Sunoco TH Fluid
Texaco TDH
5384 ;)5&80.( 08.) 37 0.1&7* *&9; 87;
37* The fluids within this group are interchangeable.
! $ &27.=:*&5 -;)5&80.( +08.)
Mobil DTE 26
Amoco Rykon AW No. 68
Castrol AWS 68
Chevron Hydraulic Oil AW ISO 68
Conoco Hydroclear AW 68
Exxon Nuto H 68
Gulf Harmony 68AW
Kendall Four Seasons AW 68
Marathon ISO 68
Pennzbell AW Hydraulic Oil 68
Phillips Magnus A ISO 68
Shell Tellus 68
76 Lubricants AW 68
Sunoco SunVis 868
Texaco Rando HD 68
"" Group 1 fluids are recommended for use
at typical ambient temperatures of 32F (0C) to 105F
(41C). The ISO Type 46/48 fluid has been found to
offer optimal performance in a wide range of
temperature conditions for the average user. The
Universal Tractor Fluids offer similar performance for
those who prefer them, with perhaps some slight loss
of efficiency at high ambient temperatures compared
to the Type 46/48 fluids.
Group 2 fluids are recommended for heavyĆduty use in
hot climates where ambient temperatures range from
about 70F (20C) to 120F (49C). Use at lower
ambient temperatures may result in hard starting,
increased engine laboring while cold, sluggish or
nonĆoperating spool valves while cold and high filter
backĆpressure due to the higher viscosity of these
fluids.