Operator's Manual

24
Lubrication
The traction unit has grease fittings that must be
lubricated regularly with No. 2 General Purpose Lithium
Base Grease. If the machine is operated under normal
conditions, lubricate all bearings and bushings after every
50 hours of operation. Lubricate the fittings immediately
after every washing, regardless of the interval listed.
The traction unit bearings and bushings that must be
lubricated are: Rear wheel hub (1), Castor bearing (1),
Steering cylinder (2) (Fig. 16), Lift arms (3) (Fig. 17),
Traction pedal pivot (1) (Fig. 18).
1. Wipe grease fitting clean so foreign matter cannot be
forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe up excess grease.
4. Apply grease to reel motor spline shaft and onto lift
arm when cutting unit is removed for service.
5. Apply a few drops of SAE 30 engine oil or spray
lubricant (WD 40) to all pivot points daily after
cleaning.
Figure 16
Figure 17
Figure 18
Before servicing or making adjustments to the machine,
stop the engine and remove the key from the switch.
CAUTION