Operator's Manual
14
2. All cutting units are shipped with the counter weight
mounted to the left end and the drive coupler mounted
in the right end of the cutting unit. To mount the
cutting unit in the right front position, proceed as
follows:
A. Remove the 2 capscrews and washers securing the
counter weight to the left end of the cutting unit.
Remove the counter weight (Fig. 10, inset).
1
2
3
4
Figure 10
1. Counter weight
2. Snap ring
3. Drive coupler
4. Plastic spacer
B. Remove the plastic spacer at both ends of the
cutting unit (Fig. 10).
C. Remove the snap ring securing the drive coupler in
the right bearing housing. Remove the drive
coupler.
D. Apply grease to the inside diameter of the drive
coupler. Install the drive coupler to the left end of
the cutting unit with a snap ring (Fig. 10).
E. Install the plastic spacer (tapered end toward the
bearing) at both ends of the cutting unit.
F. Install the counter weight to the right end of the
cutting unit with the screws and lockwashers.
3. If you are installing Greensmaster 3200 cutting units
with serial numbers ranging from 50001 through
99999, proceed as follows:
A. Remove and discard the front shield assembly
(Fig. 11). Also, remove and discard the shield
mounting studs and fasteners secured to each
cutting unit side plate.
B. Remove the single-point pull arm from the front
roller and discard.
C. Bend the grass shield side deflectors outward until
they are flush with the cutting unit side plates
(Fig. 11).
1
2
3
Figure 11
1. Front shield assembly
2. Front shield mounting
studs
3. Grass shield side
deflectors
4. Thread a ball stud into each end of the cutting unit
front roller (Fig. 13).
5. Slide the cutting unit under the pull frame while
hooking the lift roller onto the lift arm. To facilitate
installation of the rear cutting unit, the pull frame can
be rotated and latched into a service position:
A. Lower the suspension system completely (cylinders
extended).
B. Lift the carrier frame by hand until the anti-scalp
rollers clear the brake linkage.
C. Lift up on the slotted link and rotate the pull frame
into the wire hook (Fig. 12).
1
2
Figure 12
1. Slotted link 2. Wire hook