Operator's Manual

13
1
2
Figure 4
1. Negative (–) 2. Positive (+)
Installing the Steering Wheel
1. Slide the steering wheel onto the steering shaft.
1
2
3
Figure 5
1. Steering wheel
2. Jam nut
3. Cap
2. Secure the steering wheel to the shaft with the jam nut
(Fig. 5) and tighten it to 20–26 ft.-lb.
3. Install the cap to the steering wheel with the screw
(Fig. 5).
Installing the Breather
Extension and Reservoir Cap
1. Remove the breather cap from the hydraulic reservoir
(Fig. 6).
1
2
4
3
Figure 6
1. Hydraulic reservoir
2. Breather cap
3. Breather extension
4. Reservoir cap
2. Thread the breather extension into the reservoir (Fig. 6).
3. Thread the breather cap into the breather extension
(Fig. 6).
4. Remove and discard the shipping cap from the
hydraulic reservoir. Install the cap secured to the
machine.
Mounting the Front Rollers
1. Mount an anti-scalp roller and a pull link assembly to
the outer end of each front carrier frame with a roller
shaft, spacer, washer, and screw (Fig. 7). Make sure the
nylon bushing is in the pull link.
1
4
5
6
2
3
Figure 7
1. Pull link assembly
2. Pull link extension
3. Ball joint receiver
4. Nylon bushing
5. Spacer
6. Washer
2. Make sure all tires are inflated to 8–12 psi.