Service Manual

Greensmaster 3250--D
Hydraulic System (Rev. I)
Page 4 -- 74
Reel Motors
1. Cap screw
2. Flat washer
3. Tube clamp
4. Lock nut
5. Plug
6. 90
o
Hydraulic fitting
7. Hydraulic fitting
8. Hydraulic fitting
9. Not used
10. Bulkhead nut
11. Washer
12. Spacer
13. Reel motor
14. Hose assembly
15. Hose assembly
16. Hydraulic fitting
17. Hose assembly
18. T--block
19. Cap screw
20. Hydraulic tube
21. Hydraulic tube
22. Hydraulic tube
23. Hydraulic tube
24. Rubber grommet
25. O--ring
26. O--ring
27. O--ring
28. O--ring
29. O--ring
30. O--ring
31. O--ring
Figure 44
4
20
23
22
21
16
5
18
15
14
17
7
6
8
13
7
12
19
24
10
11
11
7
17
6
13
8
14
15
1
3
2
3
25
26
27
28
28
27
30
29
30
29
FRONT
RIGHT
31
FRONT REEL MOTORS
Removal (Fig. 44 and 45)
1. Before removing any parts from the hydraulic sys-
tem, park machine on a level surface, engage parking
brake, lower cutting units, and stop engine.
CAUTION
Before continuing further, read and become fa-
miliar with General Precautions for Removing
and Installing Hydraulic System Components.
2. Remove reel motor from the cutting unit (see Cut-
ting Unit Removal and Installation in Chapter 7-- Cutting
Units).
Note: The position of hydraulic fittings on the reel mo-
tor is critical to properly reconnecting hydraulic hoses.
3. Label all hose connections for reassembly pur-
poses. Matchmark reel motor and all hydraulic fittings
for reassembly purposes.