Service Manual

Rev. I
Greensmaster 3250--D
Dual Point Adjust C utting Units (Rev. D)
Page 7.1 -- 3
Special Tools
Order special tools from your Toro Distributor. Some tools may have been supplied with your mower or
available as TORO parts. Some tools may also be avail-
able from a local supplier.
Gauge Bar Assembly
Used to verify height--of--cut.
Toro Model Number: 13--8199
Figure 2
Backlapping Brush Assembly
Used to apply lapping compound to cutting units while
keeping the operator’s hands at a safe distance from the
rotating reel.
Toro Model Number: TOR299100
Figure 3
Bedknife Screw Tool
This screwdriver--type bit is made to fit Toro bedknife at-
taching screws. Use this bit with a torque wrench to se-
cure the bedknife to the bedbar.
IMPORTANT: DONOT use and air or manual impact
wrench with this tool so damage to the bedbar will
be prevented.
Toro Model Number: TOR510880
Figure 4
Roller Bearing Installation Tools
Washers and spacer used to install bearings and seals
into front and rear rollers that have a threaded roller
shaft.
Seal installation washer (black): # 107--8133
Seal installation spacer: # 107 --3505
Bearing installation washer (yellow): # 104--6126
Figure 5
Seal Installation
Washer
Seal Installation
Bearing Installation
Washer
Spacer
DPA Cutting
Units