Operator's Manual

2
All Rights Reserved
Printed in the USA
 2001 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Contents
Page
Introduction 2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Optional Equipment 2. . . . . . . . . . . . . . . . . . . . . . . . . .
Setup 3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Loose Parts 3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Adjusting the Bedknife to the Reel 3. . . . . . . . . . . .
Adjusting the Shield Height 4. . . . . . . . . . . . . . . . .
Adjusting the Top Bar 5. . . . . . . . . . . . . . . . . . . . .
Adjusting the Height of Cut 5. . . . . . . . . . . . . . . . .
Maintenance 6. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Lubrication 6. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Reel Lapping 6. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Removing the Bedknife for Grinding 6. . . . . . . . . .
Preparing the Reel for Grinding 7. . . . . . . . . . . . . .
Servicing and Adjusting the Reel Bearings 7. . . . .
Removing the Reel Assembly 8. . . . . . . . . . . . . . .
Leveling the Rear Roller Assembly to the Reel 9. .
The Toro General Commercial Products Warranty 12. .
Introduction
Read this manual carefully to learn how to operate and
maintain your product properly. The information in this
manual can help you and others avoid injury and product
damage. Although Toro designs and produces safe
products, you are responsible for operating the product
properly and safely.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model and
serial numbers of your product ready. Figure 1 illustrates
the location of the model and serial numbers on the
product.
1
m–5077
Figure 1
1. Location of the model and serial numbers
Write the product model and serial numbers in the space
below:
Model No.
Serial No.
This manual identifies potential hazards and has special
safety messages that help you and others avoid personal
injury and even death. Danger, Warning, and Caution are
signal words used to identify the level of hazard. However,
regardless of the hazard, be extremely careful.
Danger signals an extreme hazard that will cause serious
injury or death if you do not follow the recommended
precautions.
Warning signals a hazard that may cause serious injury or
death if you do not follow the recommended precautions.
Caution signals a hazard that may cause minor or moderate
injury if you do not follow the recommended precautions.
This manual uses two other words to highlight information.
Important calls attention to special mechanical
information and Note: emphasizes general information
worthy of special attention.
Optional Equipment
Swaged Roller Kit Model No. 04414
Full Roller Kit Model No. 04412
Wiehle Roller Kit Model No. 04424
Aluminum Wiehle Roller Kit Model No. 04426
Rear Roller Cleaner Part No. 42-4820
Basket Reinforcement Kit Part No. 26-0900
Variable Quick Height-of-Cut Kit Part No. 24-9400
Quick Height-of-Cut Kit Part No. 29-5910
Scraper Comb Assembly Part No. 11-0700
Tournament Bedknife Part No. 94-6394
Lo-Cut Bedknife Part No. 63-8500
Hi-Cut Bedknife Part No. 62-2510
Fairway Bedknife Part No. 63-8610
Scraper/Brush Assembly Part No. 33-1000