FORM NO. 3317-474 MODEL NO. 04480-60001 & UP MODEL NO. 04481-60001 & UP OPERATOR'S MANUAL 8 & 11 BLADE CUTTING UNITS (For GreensmasterR 3200) Helping you put quality into play.
TABLE OF CONTENTS Page SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . ADJUSTING CUTTING UNIT . . . . . . . . . . . . . . . . . . . Adjusting Bedknife To Reel . . . . . . . . . . . . . . . . Leveling Front Roller To Reel . . . . . . . . . . . . . . Adjusting Height-of-Cut . . . . . . . . . . . . . . . . . OPERATING INSTRUCTIONS . . . . . . . . . . . . . . . . . . Cutting Unit Daily Adjustments . . . . . . . . . . . . . 2 3 4 4 5 5 5 Page LUBRICATION . . . . . . . . . . . . . . . . .
ADJUSTING CUTTING UNITS IMPORTANT: Read this Operator's Manual thoroughly before operating cutting unit. Failure to do so may result in damage to the cutting unit. Note: Left and right sides of cutting unit refer to normal operating position. After the cutting unit is unboxed, use the following procedures to assure the cutting units are adjusted properly. 1. Check each end of the reel for grease. Grease should be visibly evident in the reel bearings. 2. Insure that all nuts and bolts are securely fastened.
ADJUSTING CUTTING UNITS ADJUSTING HEIGHT OF CUT (Fig. 4) 1. Verify that front roller is level and bedknife to reel contact is correct. 2 2. Turn cutting unit over (90_) and rest it on rear roller and top rear tabs. Loosen locknuts on capscrews retaining rear roller brackets. 3. On gauge bar (Part no. 13-8199), set head of screw to desired height of cut. This measurement is from bar face to underside of screw head. 1 Figure 3 1. Right front roller bracket 2. Upper right roller mounting bolt 4.
OPERATING INSTRUCTIONS CUTTING UNIT DAILY ADJUSTMENTS Prior to each day's mowing, or as required, each cutting unit must be checked to verify proper bedknife-to-reel contact. This must be performed even though quality of cut is acceptable. IMPORTANT: Light contact is preferred at all times. If light contact is not maintained, bedknife / reel edges will not sufficiently self-sharpen and dull cutting edges will result after a period of operation.
BACKLAPPING CUTTING UNITS CAUTION Be careful when lapping the reel because contact with the reel or other moving parts can result in personal injury. 1. Position machine on a clean, level surface, lower the cutting units, stop the engine, engage parking brake and remove key from ignition switch. 2. Remove reel motors from cutting units and disconnect and remove cutting units from lift arms. 6 3.
NOTES 7
The Toro Promise A One Year Limited Warranty The Toro Company promises to repair your TORO Product if defective in materials or workmanship. The following time periods from the date of purchase apply: Commercial Products . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Year The cost of parts, labor and transportation are included.
