Service Bulletin

Customer Service Bulletin
Commercial Business Group
Greensmaster
®
3200 and 3200-D
Model/Serial Range: Model Number: Serial Numbers:
04380 60001-60750
04381 60001-60659
04382 60001-60800
04383 60001-61215
Subject: Missing or mis-located Decal may cause wrong cutting unit set up.
Some cutting units may have been produced without the decal that identifies the front roller
position or the decal may have been installed in the wrong location. An incorrectly located
decal will result in an improper attitude of the bedknife, which could result in quality-of-cut
issues. Replacement decals are available through your local Toro distributor. Instructions
for checking the proper decal location are described below.
ROLLER BRACKET DECAL INSTALLATION INSTRUCTIONS
for GREENSMASTER 3200/3200-D Cutting Units
1. Assemble the Front Roller Brackets in the appropriate “Figure-Eight” hole locations as shown.
2. The notch on the brackets should align with position 2 on the decal.
3. Remove and install a replacement Bracket Positioning Decal (94-8169) as necessary to complete
the assembly.
Front Roller Bracket
Install bolt through top of both
‘figure-eight’ shaped holes.
Eccentric Bolt
Bracket shown in
# 2 position.
Line up # 2 on decal
with notch on Bracket
Ref: 14-06 Copyright

, 1996. The Toro Company