Installation Instructions

ManualsBrandsToro ManualsRiding ProductsLight Kit, Greensmaster 3360 or 3370 eTriFlex Traction Unit

FormNo.3429-423RevC

LightKit

Greensmaster

eTriFlex3360or3370TractionUnit

ModelNo.04500

InstallationInstructions

Note:Anadditionaldecal(PartNo.127-6126)andfuseblade(15A)areincludedinthiskit.Thesepartsare

notusedfortheeTriFlexmachines;youmaydiscardthem.

Safety

SafetyandInstructionalDecals

Safetydecalsandinstructionsareeasilyvisibletotheoperatorandarelocatednearanyarea

ofpotentialdanger.Replaceanydecalthatisdamagedormissing.

decal127-6126

127–6126

1.Headlights3.Headlightsandrearlights

2.Off

decal131-2046

131-2046

1.Doublelights

3.Off

2.Singlelight

Installation

PreparingtheMachine

NoPartsRequired

Procedure

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Lowerthecuttingunits.

4.Shutoffthemachineandremovethekey.

5.Disconnectthemain-powerconnectors;referto

yourmachineOperator’sManual.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3429-423*

Summary of content (4 pages)

PAGE 1
Form No. 3429-423 Rev C Light Kit Greensmaster® eTriFlex 3360 or 3370 Traction Unit Model No. 04500 Installation Instructions Note: An additional decal (Part No. 127-6126) and fuse blade (15 A) are included in this kit. These parts are not used for the eTriFlex machines; you may discard them. Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing.
PAGE 2
. 2 Installing the Lights 3 Parts needed for this procedure: 2 Light assembly 1 Left bracket 1 Right bracket 2 U-bolt 4 Nut (3/8 inch) Installing the Wire Harness and Switch Parts needed for this procedure: Procedure 1. Use the bolt, washer, and nut included with each headlight assembly to Install the headlights as shown in Figure 1. 1 Wire harness 10 Cable tie (14-1/2 inches) 2 Cable tie (7-1/4 inches) 1 Switch 1 Decal (Part No.
PAGE 3
6. Route the remaining wire-harness leg up through the bottom of the seat plate and following the machine wire harness towards the console (Figure 3). 7. In the console, connect the wire-harness connector labeled TO MAIN HARNESS with the machine-wire-harness connector labeled OPTIONAL WORKLIGHT KIT. Installing the Switch and Decal 1. Remove the plug from the console (Figure 4). g279205 Figure 2 1. Cable tie (14-1/2 inches) 5. 2.
PAGE 4
3. Operation Connect the wire-harness connector labeled WORK LIGHT SWITCH to the switch (Figure 4) and install the switch. Operating the Lights Observe the correct orientation of the switch as shown in Figure 5. Note: To adjust the lights, loosen the mounting hardware, aim the lights as desired, and tighten the hardware. Refer to Figure 6 for this procedure. • Moving the switch to the RIGHT position activates the headlights and rear light (if equipped).