Service Manual

Greensmaster 3320/3420Hydraulic System Page 5 − 22
High Flow Hydraulic Filter Kit
The high flow hydraulic filter kit is designed with large
flow (40 GPM/150 LPM) and high pressure (5000
PSI/345 bar) capabilities. This kit provides for bi−direc-
tional filtration which prevents filtered debris from being
allowed back into the circuit regardless of flow direction.
If a component failure occurs in the closed loop traction
circuit, contamination from the failed part will remain in
the circuit until removed. When connecting hydraulic
test gauges in order to test traction circuit components
or after replacing a failed traction circuit component (e.g.
piston (traction) pump or wheel motor), the high flow hy-
draulic filter can be installed in the traction circuit. The
filter will ensure that contaminates are removed from the
closed loop and thus, do not cause additional compo-
nent damage.
Toro Part Number: TOR6011
NOTE: This kit does not include hydraulic hoses (see
Hydraulic Hose Kit TOR6007 above).
NOTE: Replacement filter element is Toro part number
TOR6012. Filter element cannister tightening torque is
25 ft−lb (34 N−m).
Figure 17
Hydraulic Test Fitting Kit
This kit includes a variety of O−ring face seal fittings to
enable you to connect test gauges into the system.
The kit includes: tee’s, unions, reducers, plugs, caps
and male test fittings.
Toro Part Number: TOR4079
Figure 18
TORO TEST FITTING KIT (NO. TOR4079)