Installation Instructions

Printed in the USA

 2002 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Roll-Over Protection Kit

Greensmaster



3200, 3200-D, and 3250-D

Model No. 04552

Form No. 3327-696

Installation Instructions

If you leave the key in the ignition switch, someone

could accidently start the engine and seriously

injure you or other bystanders.

Remove the key from the ignition and disconnect

the wire(s) from the spark plug(s) before you do

any maintenance. Set the wire(s) aside so that it

does not accidentally contact the spark plug(s).

Caution

Installing the Seat Belts

1. Attach each end of the seat belt to the holes in the back

of the seat with screws (7/16 x 1 in.) and lock washers

(7/16 in.) (Fig. 1). Tighten them securely. Mount the

latch side of the belt to the left side of the seat.

Note: When operating the machine, always use the seat belt

and ROPS together.

Figure 1

1. Seat belt

2. Lynch pin

3. Seat pin

4. Seat support

2. Install the lynch pin into the seat pin to secure the seat

support (Fig. 1).

Installing the ROPS

1. Lower the ROPS frame onto the mounting brackets,

aligning the mounting holes as shown in Figure 2.

Note: To allow installation of the ROPS mounting nut on

the right side of the machine, the double clamp holding the

steering cylinder hoses next to the ROPS support must be

rotated 180°.

2. Secure each side of the roll bar to the mounting brackets

with 2 bolts (5/8 x 4-1/2 in.) and locknuts (Fig. 2).

Torque the fasteners to 135–165 ft.-lb. (183–224 N⋅m).

Note: When operating the machine, always use the seat belt

and ROPS together.

Figure 2

1. ROPS