Installation Instructions
11
10. Remove the cap plug from the groomer housing
(Fig. 36).
1
Figure 36
1. Cap plug
11. Remove the nut securing the groomer shaft to the
groomer housing.
12. Remove the groomer shaft.
13. Assemble the shaft in reverse order. Using the location
marks on each blade as a guide, assemble each blade
so that the location mark is offset one flat on the
hexagonal shaft.
Note: The location marks on each blade are offset so that
they can be used to achieve proper grooming reel setup.
Stack the blades and match the location marks before
installing them on the grooming reel shaft.
2
1
3
4
Figure 37
1. Grooming blade
2. Dull (rounded) edge
3. Sharp edge
4. Location mark
14. Torque the lock nuts to 200–250 in.–lb.
(22.6–28.3 N⋅m).
15. Check the grooming reel height/depth setting.