Installation Instructions
1
All Rights Reserved
Printed in the USA
W 2003, 2004, 2007 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Rear Roller Brush Kit
Greensmaster
)
3150 & 3250
Model No. 04640
Model No. 04641
Form No. 3328–808 Rev. B
Installation Instructions
Note: The Rear Roller Brush Kit can only be installed on
cutting unit models 04610 and 04611.
Note: The left-hand brush drives are shown in all figures.
Loose Parts
Description Qty.
04640
Qty.
04641
Roller brush assembly (L.H.) 3 2
Roller brush assembly (R.H.) 0 1
Capscrew
Flange nut
12
12
12
12
Bearing spacer
Flat washer
Capscrew
3
3
3
3
3
3
Drive pulley
Washer
Flange head capscrew
3
3
3
3
3
3
Rubber grommet
(For use with groomer)
3 3
Drive pulley
Capscrew
(For use with groomer)
3
3
3
3
V–Belt 3 3
Installation instructions 1 1
Parts catalog 1 1
Installation on Cutting Units Without
Groomer
1. Remove (2) nuts securing belt cover to brush kit drive
assembly (Fig. 1). Remove cover and set aside for now.
Note: Account for (2) shoulder spacers on cover mounting
studs.
1
2
3
Figure 1
1. Belt cover
2. Drive assembly
3. Shoulder spacer (2)
2. Remove fasteners securing counterweight to end of
cutting unit (Fig. 2). Remove counterweight.
2
1
3
Figure 2
1. Counterweight
2. Plug
3. Boss
3. Remove plug from counterweight (Fig. 2).
4. Re–install counterweight to cutting unit or groomer
cover to groomer drive assembly with mounting
fasteners previously removed.