Form No. 3402-426 Rev A Dethatching Unit Greensmaster® 3300/3400 Series TriFlex® Traction Unit Model No. 04720—Serial No. 315000001 and Up Register at www.Toro.com.
WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Introduction This product complies with all relevant European directives. For details, please see the Declaration of Incorporation (DOI) at the back of this publication. Figure 1 1.
Contents Safety Safety ........................................................................... 3 Safety and Instructional Decals ................................. 4 Setup ............................................................................ 5 1 Installing the Front Roller ...................................... 5 2 Adjusting the Reel Blades for Positive Setting (Above Ground).................................................. 5 3 Adjusting the Reel Blades For Negative Setting (Below Ground) .....
Never use "will-fit" replacement parts and accessories made by other manufacturers. Look for the Toro logo to assure genuineness. Using unapproved replacement parts and accessories could void the warranty of The Toro Company. Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 104-7729 1. Warning—read the instructions before servicing or performing maintenance. 2.
Setup 4. Rotate the height-of-cut until both ends of the front roller contact the level surface. 5. Verify contact by using a piece of paper to check each roller end. 1 6. Tighten both height-of-cut knob locknuts. Installing the Front Roller 3 No Parts Required Adjusting the Reel Blades For Negative Setting (Below Ground) Procedure The dethatching unit is shipped without a front roller.
4 Installing the Dethatching Reel No Parts Required Procedure See the traction unit Operator’s Manual for installing the reel to the machine. Important: If you set the dethatching reel at a negative setting, take care to prevent damaging the reel blades due to contact with concrete floors or paved surfaces.
Product Overview Specifications Tractors These dethatching units will mount on the Greensmaster 3300 and 3400 Traction Units. Height-of-cut Dethatching depth is adjusted on the front roller by two vertical screws and held by two locking capscrews Height-of-cut Range Bench HOC range is 4.78 mm (0.188 inch) below ground level to 6.35 mm (0.250 inch) above ground level. Reel Bearings Two sealed stainless steel, deep groove ball bearings. Rollers The rear roller is a 5.
Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Disassembling the Reel Disassemble the reel whenever you need to change a blade or replace the reel bearings. Important: Ensure that the 2 shaft retainers and spacer are in place before installing the bearing on the reel (Figure 5). Torque the insert nuts to 136 N-m (100 ft-lb). Figure 5 1. Left-hand threaded insert nut 2. Bearing 4. Spacer 3. Seal 6. Shaft retainer (install these first) 5.
Notes: 9
Declaration of Incorporation The Toro Company, 8111 Lyndale Ave. South, Bloomington, MN, USA declares that the following unit(s) conform(s) to the directives listed, when installed in accordance with the accompanying instructions onto certain Toro models as indicated on the relevant Declarations of Conformity. Model No. 04720 Serial No.
International Distributor List Distributor: Agrolanc Kft Asian American Industrial (AAI) B-Ray Corporation Brisa Goods LLC Casco Sales Company Ceres S.A. CSSC Turf Equipment (pvt) Ltd. Cyril Johnston & Co. Cyril Johnston & Co. Fat Dragon Femco S.A. FIVEMANS New-Tech Co., Ltd ForGarder OU G.Y.K. Company Ltd. Geomechaniki of Athens Golf international Turizm Hako Ground and Garden Hako Ground and Garden Hayter Limited (U.K.) Hydroturf Int. Co Dubai Hydroturf Egypt LLC Irrimac Irrigation Products Int'l Pvt Ltd.
The Toro Warranty A Two-Year Limited Warranty Conditions and Products Covered The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first. This warranty is applicable to all products with the exception of Aerators (refer to separate warranty statements for these products).
