Form No. 3370-373 Rev A Dethatching Unit Greensmaster® 3300/3400 Series TriFlex™ Traction Unit Model No. 04720—Serial No. 312000001 and Up To register your product or download an Operator's Manual or Parts Catalog at no charge, go to www.Toro.com.
This manual identifies potential hazards and has safety messages identified by the safety alert symbol (Figure 2), which signals a hazard that may cause serious injury or death if you do not follow the recommended precautions. Introduction This product complies with all relevant European directives. For details, please see the separate product specific Declaration of Conformity (DOC) sheet.
Safety Wearing safety glasses, safety shoes, and a helmet is advisable and required by some local ordinances and insurance regulations. Hazard control and accident prevention depend upon the awareness, concern, and proper training of the personnel involved in the operation, transport, maintenance, and storage of the machine. Improper use or maintenance of the machine can result in injury or death. To reduce the potential for injury or death, comply with the following safety instructions.
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 4 Description Use Qty. No parts required – Install the front roller. No parts required – Install the dethatching reel. 1 Installing the Front Roller No Parts Required Procedure The dethatching unit is shipped without a front roller. Install the roller using the loose parts supplied with the dethatching unit and installation instructions included with the roller. Figure 3 2 1. Gauge bar 3.
3 4 Adjusting the Reel Blades For Negative Setting (Below Ground) Installing the Dethatching Reel No Parts Required Procedure No Parts Required Important: If you set dethatching reel at a negative setting, take care to prevent damaging the reel blades, due to contact with concrete floors or paved surfaces. Procedure Note: Maximum recommended negative setting is 3/16-inch (5 mm) deep blade penetration. 1. Place the dethatching unit on a level surface. 2.
Product Overview Specifications Tractors These dethatching units will mount on the Greensmaster 3300 and 3400 Traction Units. Height-of-cut Dethatching depth is adjusted on the front roller by two vertical screws and held by two locking capscrews Height-of-cut Range Reel Bearings Rollers Bench HOC range is .188 inch (4.78 mm) below ground level to .250 inch (6.35 mm) above ground level. Two sealed stainless steel, deep groove ball bearings. The rear roller is a 2 inch (5.
Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Disassembling the Reel Disassemble the reel whenever you need to change a blade or replace the reel bearings. Important: Ensure that the 2 shaft retainers and spacer are in place before installing the bearing on the reel (Figure 5). Torque the insert nuts to 100 lb-ft (136 N-m). Figure 5 1. Left-hand threaded insert nut 2. Bearing 3. Seal 4. Spacer 5. Slot in shaft 6.
The Toro Total Coverage Guarantee A Limited Warranty Conditions and Products Covered The Toro® Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first. This warranty is applicable to all products with the exception of Aerators (refer to separate warranty statements for these products).
