Operator's Manual

ManualsBrandsToro ManualsAttachmentsTri-Roller, Greensmaster 3300/3400 Series TriFlex Traction Unit

FormNo.3429-437RevA

Tri-Roller

Greensmaster

3300/3400SeriesTriFlex

TractionUnit

ModelNo.04722—SerialNo.403370001andUp

Operator'sManual

Introduction

Readthisinformationcarefullytolearnhowtooperate

andmaintainyourproductproperlyandtoavoid

injuryandproductdamage.Youareresponsiblefor

operatingtheproductproperlyandsafely.

Visitwww.Toro.comforproductsafetyandoperation

trainingmaterials,accessoryinformation,helpnding

adealer,ortoregisteryourproduct.

Wheneveryouneedservice,genuineT oroparts,or

additionalinformation,contactanauthorizedToro

distributorandhavethemodelandserialnumbersof

yourproductready.Themodelandserialnumbers

arelocatedonaplateontherearframe.Writethe

numbersinthespaceprovided.

Important:Withyourmobiledevice,youcan

scantheQRcode(ifequipped)ontheserial

numberdecaltoaccesswarranty,parts,andother

productinformation.

g279029

Figure1

1.Modelandserialnumberlocation

Thismanualidentiespotentialhazardsandhas

safetymessagesidentiedbythesafety-alertsymbol

(Figure2),whichsignalsahazardthatmaycause

seriousinjuryordeathifyoudonotfollowthe

recommendedprecautions.

g000502

Figure2

Safety-alertsymbol

Thismanualuses2wordstohighlightinformation.

Importantcallsattentiontospecialmechanical

informationandNoteemphasizesgeneralinformation

worthyofspecialattention.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3429-437*A

Summary of content (8 pages)

PAGE 1
Form No. 3429-437 Rev A Tri-Roller Greensmaster® 3300/3400 Series TriFlex® Traction Unit Model No. 04722—Serial No. 403370001 and Up Operator's Manual Introduction Read this information carefully to learn how to operate and maintain your product properly and to avoid injury and product damage. You are responsible for operating the product properly and safely. Visit www.Toro.com for product safety and operation training materials, accessory information, help finding a dealer, or to register your product.
PAGE 2
Setup 1 Installing the Tri-Roller Units No Parts Required Procedure 1. 2. 3. g018312 Park the machine on a level surface, shut off the engine, engage the parking brake, and remove the key. 1. Suspension-arm bar Position the tri-roller unit under the suspension arm. 4. Figure 4 With the latches on the suspension-arm bar pointing up (Figure 3), push the suspension arm down so that the bar fits over the bar across the top of the tri-roller unit (Figure 4).
PAGE 3
2 Removing the Tri-Roller Unit No Parts Required Procedure 1. Park the machine on a clean level surface, lower the tri-roller units to the ground until the suspension hydraulics are fully extended, shut off the engine, engage the parking brake, and remove the key from the ignition switch. 2. Push the motor retaining bar out of the slots on the motor toward the tri-roller unit and remove the motor from the tri-roller unit. g014690 Figure 5 1. Motor 3. Cavity 2. Spline shaft 4.
PAGE 4
7. Repeat steps 2 through 6 for the other tri-roller units as required. 3 Adding Rear Weight Parts needed for this procedure: 1 Weight kit, 119-7129 (purchase separately) Procedure g254873 This machine complies with the ANSI B71.4-2017 and EN ISO 5395 Standards when equipped with the Weight Kit, Part No. 119-7129. Figure 7 1. Cap screws Operation 2.
PAGE 5
Maintenance Lubricating the Tri-Roller Lubricate the 2 grease fittings (Figure 8) on each tri-roller unit after every 15 hours of operation, with No. 2 lithium grease. Use a hand-operated grease gun for best results. 1. Wipe each grease fitting with a clean rag. 2. Apply grease to the tri-roller shaft bearings until you feel pressure (Figure 8). g018317 Figure 8 3. Wipe excess grease away.
PAGE 6
Declaration of Incorporation The Toro Company, 8111 Lyndale Ave. South, Bloomington, MN, USA declares that the following unit(s) conform(s) to the directives listed, when installed in accordance with the accompanying instructions onto certain Toro models as indicated on the relevant Declarations of Conformity. Model No. 04722 Serial No.
PAGE 7
EEA/UK Privacy Notice Toro’s Use of Your Personal Information The Toro Company (“Toro”) respects your privacy. When you purchase our products, we may collect certain personal information about you, either directly from you or through your local Toro company or dealer.
PAGE 8
The Toro Warranty Two-Year or 1,500 Hours Limited Warranty Conditions and Products Covered Parts The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial product (“Product”) to be free from defects in materials or workmanship for 2 years or 1,500 operational hours*, whichever occurs first. This warranty is applicable to all products with the exception of Aerators (refer to separate warranty statements for these products).